to clean the vcfront, you need to remove the 12v li-ion and connect the usual acid one instead
after that, you can clear the errors in the vcfront model 3 Y block
but it's too early to install 12 v li-ion because it needs to be charged and most importantly, clear the crash
remove it from the machine for future work on the table
you need to use a hair dryer to open the lid
first you need to unscrew the bolts and remove 2 plugs
after 3 minutes of warming up, pry with a flat screwdriver
remove some more plugs
in order to charge it on the table
need to:
1) unsolder plus
2) disable the balancing plug
very carefully connect the probes after setting the current and voltage
checking bank voltage
3.73v is considered ok
solder 4 pins to vvdi prog programmer
choose a chip
